Chapter 1: Introduction Concepts of Stress
1.1 Introduction 
1.2 Modeling of Structures 
1.3 Concepts of Stress
1.4 Stress on an Oblique Plane under Axial loading
1.5 Stress under General loading conditions
1.6 Design Considerations
Chapter 2: Stress Strain. Axial Loadings
2.1 Introduction
2.2 Normal Strain under Axial loading
2.3 Stress- Strain Diagram
2.4 Hooke’s law. Modulus of Elasticity. Poisson’s ratio
2.5 Multi-axial loading. Generalized Hooke’s law 
2.6 Statically Indeterminate Problem
2.7 Deformation involved by temperature change
2.8 Stress concentration
Chapter 3: Torsion
3.1 Introduction 
3.2 Stress in a shaft 
3.3 Deformation in a Circular Shaft
3.4 Stress and deformation in the elastic range
3.5 Statically Indeterminate Shafts
3.6 Design of Transmission Shafts
3.7 Torsion of Noncircular Shafts
3.8 Thin-Walled Hollow Shafts
Chapter 4: Pure bending
4.1 Introduction
4.2 Symmetric members in Pure bending
4.3 Deformation in Pure bending
4.4 Stress and deformation in elastic range
4.5 Bending of members made of several materials
4.6 Eccentric Axial loading in a Plane of Symmetry
4.7 Unsymmetrical bending
4.8 General case of Eccentric Axial loading
Chapter 5: Analysis and design of beam for bending
5.1 Introduction
5.2 Shear and bending moment Diagram
5.3 Relation among Load, Shear force and bending moment
5.4 Design of Prismatic beams for bending
5.5 Using Singularity Functions to Determine Shear force and bending moment
5.6 Non-prismatic Beams
Chapter 6: Transformations of stress and strain
6.1 Introductrion
6.2 Transformation of Plan Stress
6.3 Principal Stresses. Maximum Shearing stress
6.4 Mohr’s Circle for Plane Stress
6.5 General State of Stress. Application of Mohr’s Circle for Three- Dimensional Analysis of Stress
6.6 Transformation of strain. Three-dimensional state of strain
6.7 Failure criteria for ductile and brittle materials
6.8 Stress in Thin-walled pressure vessels
Chapter 7: Principal Stresses under a given loading
7.1 Introduction
7.2 Principal Stress in a Beam
7.3 Design of Transmission Shafts
7.4 Stresses under Combined loadings